Switched from coal to propane in my garage forge and I'm not going back
I ran bituminous coal in a rivet forge for about 3 years out here in Spokane, and I swore by it. Then my neighbor complained about the smoke twice in one summer and the city sent a letter, so I picked up a Mr. Volcano two burner on a whim. The big thing that won me over is the heat control, since I can dial the gas back and hold a steady orange on a small knife blank instead of chasing a coal fire that runs hot and cold. Cleaner work area too, no clinker to dig out and way less ash on my bench. Curious if anyone here has run both for a long stretch, did you end up missing the coal fire for forge welding or was gas enough for you?