Traded my cheap color laser for the office inkjet and my teal finally stopped looking gray
I run a small print shop out of my garage in Dayton and last week I finally did a side by side test that I should have done a long time ago. I had been sending teal heavy flyers to a $200 color laser because it was fast, and every single run came out looking like wet concrete. On a hunch I printed the same file on our old Epson inkjet that has been sitting under the counter for about 8 months, and the difference was night and day. The teal actually read as teal, and the orange in the logo next to it didn't go muddy at the edges. The laser was blending the dots in a way that killed the whole color shift, while the inkjet laid it down clean. Problem is the inkjet takes almost 4 minutes a page on the good setting, so now I am stuck picking between slow and right. Has anyone here found a middle ground, or do I just need to eat the slower times on jobs that have bright greens and oranges in them?