Tried the dual-brush spinning setup on a tough creosote job near Richmond

Thought it was just fancy marketing but after three passes with the old single brush gave me nothing, the dual-brush spun through a half-inch of glaze in five minutes and I’m wondering if I’ve been wasting my time on the old method, has anyone else found that spinning brushes outperform the traditional hand rods on heavy deposits?

3 comments

3 Comments

robinmason11d ago

Double check the RPM rating on that dual-brush head before you get too excited. I burned up two motors in a row running them too fast on heavy glaze before I realized the manual said to keep it under 1200 for thick deposits. What brand/model were you using on that Richmond job?

tara34510d ago

Damn, that sucks. Thanks for the heads up, appreciate you sharing that.

dixon.anthony10d ago

Realized the same thing cleaning my own garage floor last month - seems like everyone rushes to buy the TOOL without reading the fine print on how to actually use it right.