Loading…
18
That fiberglass mold I left in the sun for 3 days in Tucson
I mean, I know the resin says 75 degrees is fine, but I left a boat hatch mold on my patio during that heat wave and it warped like 4 degrees off spec. Now every latch I pull from it needs shims, which is a nightmare when you're doing 12 identical units. Anyone else had a part go wavy just from storage temperatures? I'm trying to figure out if I can fix the mold or if I'm starting over.
1 comments
Log in to join the discussion
Log In1 Comment
fiona_lewis3728d ago
Three days in Tucson sun is brutal, that resin never stood a chance. Sucks that it's the latches too, those tolerances are so tight that 4 degrees might as well be a mile. I'd try to save it before you scrap the whole thing though.
-1